Search results

Hello Dynon, My setup is full Skyview system with EMS 221, Aerosport IO-375-M1S engine. I have made my 1st flight yesterday, and noticed that all 4 EGT were not reaching normal temperatures, all very low. Today I tried to troubleshoot and found out that all 4 EGT do not go over 475°F, and all 4...

That would be a great idea. I'm not flying yet, will be soon... And I'd love to be able to see all little airfields on the map as there are many in France that can be used with my plane (RV-7). Hopefully in the near future?... Alain France RV-7 flying soon.

Hi, Almost one year after my initial questions I am finally connecting my trim motors to the EMS. As a reminder i have: 2 Skyview Touch, AP module and VP-X. As discussed before I'm connecting the Ray Allen servos to the Dynon EMS to have the auto-trim function. Everything is connected, trim...

Hello Dynon, I am finishing the wiring of my skyview system which includes the SV-XPNDR-262 transponder. Yesterday I tried to see if all was good but I have a transponder fail message on the initial skyview screen, and when I go in the Transponder setup page, staus shows "NOT FOUND". In the...

Thanks for the quick reply. Yes I have checked the harness pin by pin for continuity, connection and to verify that I didn't put any pin in the wrong position. I couldn't find anything wrong. Before contacting tech support Will try to send the T8 to a friend with s similar panel and he will...

Hello Dynon, Yesterday was big day for me as I fired up my avionics for the 1st time. Full Dynon panel: 1 D-1000-T (second will be purchased soon), SV-COM-X83 + SV-COM-T8, SV-Intercom-2S, SV-AP-Panel and SV-Knob-Panel. Everything is fine except for the VHF: My SV-COM-W83 module starts fine but...

Thank you Gents, it's more clear now. I will connect to the EMS so it's all managed and controlled by the Skyview system. Alain.

OK, thank you. Just to clarify, I did not select the option for electrim trim in the VPX planner as the trim motors are powered and managed by the SV-AP-Panel. So, in this setup I can still connect the position wires to the VPX? Thanks.

Hello Dynon, I'm building a RV-7 and I'm installing the SV-AP panel in my system. I also have a VP-X Sport. My trim motors (pitch and roll) are Ray allen. The Ray Allen  trim motors have 5 wires. I see in the Dynon installation manual how to connect the two white (power) wires to each servo, but...

Thank you for that. I have to admit I haven't read the EMS section yet as I thought is only for engine sensors. I'll have to read further and think about it... Alain.

Hi. I'm new here. I am Alain, living and building an RV-7 in France. The airframe is 80% done and I will soon install avionics and engine. I'll have a Dynon Skyview system, Dynon VHF, intercom, AHDARS, EMS and the heated pitot. And a VP-X Sport. Question: The pitot heater controller has 3...