Search results

I have a Dynon HDX Panel in my experimental with Dynon Radio and Intercom. I am having a problem with the audio on the co-pilot side. Intercom between the Pilot and Co-pilot are great and on the Pilot side has the radio transmit and receive are excellent. I have had several different...

That is interesting as I have not seen anything in the Dynon manuals that indicate what you said. I am fully aware of the monitor (Dual) feature but as you stated it is only a good feature until someone keys the mic on the primary freq and that always tends to be when I am listening to the ATIS...

I thought you meant there was a way to control a second Dynon radio via the HDX screen...

Can you elaborate on "the HDX will handle dual radios just fine"? I have a dual screen HDX system with Dynon intercom and single Dynon radio and I can't figure out how to add a second radio (any kind) that the Dynon will also control without changing to a different audio panel or adding a hard...

So if I have an older UL 4 cylinder engine without the CANBUS and don't have a VPX then is there any reason to install this update?

Definitely yes, I was in and under two overlapping class Charlie airspaces...the traffic was there one second and blank screen the next.

I just noticed that there is "another" firmware release on the Dynon website. Does this fix any issues from the v 16.0.1?

Thanks for the feedback. I have flown a lot since the firmware update and this is a recent problem that only happened in the last couple of days...hope it is not a sign of something worse.

I have been flying for the past year plus a Dynon HDX plus the SV 472 and it has worked great. The last couple of flights I have had an issue where the ADS-B in has disconnected a few times in flight. It is normally not long but it is disconnecting and showing me no traffic where I know there...

I have a dual Dynon HDX screen system with Dynon Autopilot, Dynon Radio, Dynon Audiopanel and Dynon Knob Panel. The sound is fine until I reach out to touch the screen and then I get "static" which immediately goes away when I move my hand away. Any idea why this happens? And how can I fix or...

I did the setup and everything works in when doing it. But it hunts (left and right) of course when in straight and level flight.

It has Arm on Servo for both Pitch and Roll.

Maybe I didn't use the correct term...the plane hunts (left and right) of course when in straight and level flight.

I have an HDX system with Dynon 42 (Roll and Pitch) Servos installed on my Zenith CH-750 Cruzer. The system has the latest software version installed and I typically run it in simplified mode as I only fly VFR. Whenever I engage the autopilot (especially in smooth air) it tends to start...

Maybe the difference is that I have a 10 and 7" HDX not Classic...

I just installed the Knob panel (one day before V16 was released) it took a couple of reboots but it was recognized. Works great with V16. Try resetting you pin connectors, I have found that has been an issue with other connections

So I flew both Wednesday and Thursday after the software update. Both days were a bit bumpy and I definitely noticed that the Autopilot was better functioning. Previously it would not handle turbulence very well and would sometimes kick offline, but the past two days were much better...

I installed the v16 update this morning on both my 10 and 7" screens. The updated happened without incident. The only thing that I noticed and initially thought was a problem is that the on screen comms numbers are "greyed" out until that value is able to be input. i.e. When you first open...

I have used several different types and sizes of USB Drives over the past year and have not had any issues...guess I am lucky. I have two HDX, 10" with battery backup and 7" without. I always plug the Chart databases into the 7" and do the monthly updates on the 10"...

Ok, thanks.