Search results

We pay taxes too however we have to pay extra for databases etc - free weather in will probably not happen in my lifetime :D.

FWIW, I never put the potentiometers for that purpose on the panel - I remotely mount them behind the panel as once I have them ‘set’ they don’t need to be changed ;) ps - you can still ‘tweak’ them later if need be.

Thanks Tim - that's the difference I guess, it's automatic with FAA registered aircraft only - 'we' have to enter the Hex codes here. You guys have got it easy - free weather & mapping etc 🙂.

I updated post # 6 to make it clearer :).

Not sure how it's done there - our Aviation regulator (CASA) issues the Hex code with our aircraft rego (N-Number in your case) which is specific to that rego, never generated by Dynon. I just did a 'search' & found this - "How do I find my aircraft hex code? In the US, this is easily found...

Yep, change your N number in the Dynon & the Transponder Hex code that goes with the new N number ;)

FYI - always was part of the Dynon system & with the ‘legacy’ units too.;)

Ummmm 8.2 + 1.8 = ? ;)

Just a data point here -that doesn't always work.

Heading is all you will have with that unit - Alt Hold is a totally independent function & does not need or have any GPS input.

As it outputs NMEA 0183 & needs a 5 Volt power input, why don't you connect it ? Will not hurt the Dynon . However if you want it to 'drive' an autopilot to follow a GOTO or Fltplan then you're out of luck - that's better served using a Gps with database IMO.

What have you configured P24/25 to do?

It’s called out for in the install manuals😉

Just use a 10K Ohm ( it’s a turn potentiometer) resistor in the Dynon audio output wire & adjust the volume with it 😉

To little info here, it would help if you listed all the circumstances & what troubleshooting you have done.;)

I'm having the same issue - it's a problem with the NMEA datastream from the SV, IMO. Most of the time i can see it trying to work & have had it work properly on 1 short flight.

150.200.250 - where did you get that info? What you need to do is set up the PPR ( Pulse Per Revolution) which should be 2 in your case.

No worries - you will still get rpm indication changes regardless ;)

in the case of 2 x P-Mags you connect to D37 pin 32or 33 as you only need to connect 1 P-Mag as it outputs rpm regardless of whether it’s working or not. NO resistors used at all. HTH.

GPS 250 only works with Skyview systems & GPS 251 (discontinued) was for the legacy units. The baud rates are very different too.