Search results

Someone else who has got the correct settings may chime in here but the 480 should not need GAMA 429 Graphics (like the 430/530) as it will do the procedures like 'Holds' in it's own right. That took a while for Garmin the get it into their own developed products, the 480 lead the field, & some...

Oil (& Fuel Pressure) sensors use Pin 18 (5 volts) to the red wire of the sensor - it's all in the Install Manual, please read it caefully ;)

I use the Amp brand spade connectors, they work really well if used with a good quality crimper -IMO  the supplied pink ones are too good ie the material that they're stamped out of is a slightly thicker plate & are too hard to crimp properly.

1. First thing is to add a Ethernet cable connected to both screens as the EMS & some other data will seemlessly transfer. 2. # 2 D1000 - make sure you configure the serial ports same as #1 & the software vers is the same plus any mapping/databases. 3. When both are 'setup' (no need to do...

I'd confirm the PPR is correct for your engine type/number of cylinders. Increasing the resistence is most likely not what to do especially if the rpm was working well before the update.

Hi Steve I'd fix the antenna connections first, hopefully the Dynon transmitter has not been damaged.  Generally if you transmit without an antenna connected ( centre pin 'retracted' in your case) or a dummy load fitted there can be damage, the RF energy has to go somewhere & basically that...

So glad you found the problem &, as discussed offline, the issue can be caused by other power supplies like USB's.  That's why it's important to turn everything off then turn on one item at a time to determine the cause of the interference  ;)

Contact DS direct - there was an issue with some earlier EMS modules & it will need to be returned to factory, or you may try using these http://www.l-com.com/d-sub-capacitive-filter-emc-adapter-db9-male-female (25 pin as well) filtered Dsub connectors however IMO it's better to have Dynon fix...

I don't think so - I'd just connect the network cable & Dynon GPS to give fuel at waypoint etc functions as a minimum. DS may add more info.

Well done !! ;D

Basically it is the same process except the EGT probes are K type.

Steve, Pm sent.

Aha, now we know the main issue here regardless of whether you have the correct sensor or not. Read the install instructions  & refer to my post # 12 above - connect the sensor power wire to the 5 volt  white/red striped wire from the EMS module  ::) FYI - generally sensor red wires are for...

What is the voltage on the red wire at the sensor ?

Just had a wild thought - did you connect the Fuel Flow or other 12 volt wire to it ? The White/ red stripe 5volt wire is the only one to use.

Ron, FWIW - there is something else going on with your system, probably a wiring issue IMO. There is absolutely no need to add resistors to the P-Mag tach outputs from my experience with having installed many of them.

I'd be checking the sensor wire ( not the 5volt or ground) carefully, make sure the pin is pushed fully home in the 37pin connector on the EMS module. HTH

May be worth trying another number, can't hurt & worse case is it will not work ;)

You're welcome :) Some of the earlier EMS units needed returning to Dynon to 'fix' the issue.

Can you post a picture of the Input Mapping screen ?