Search results

Looks like it is a standard resistance sender. Connect one of the senders leads to a good earth, the other one connect to the Dynon wire for that tank.

The certified Dynon installation uses the P-Leads at the ignition key switch, with some resistors. The sensor that screws into the magneto are usually part of a kit from JPI or Electronics International, approved under their STC's

I have installed Dynon servos in where a Trutrak was fitted. The Dynon servos bolted straight into the Trutrak brackets. The Dynon and Trutrak servos look pretty much identical. Bendix-King bought Trutrak, so I would think the servo brackets from a BK Aerocruze would fit the Dynon servos.

First thing to go in the rubbish bin when I unpack an EMS engine kit 👌

Honestly, it sounds like a bad probe. If you have a bad connection, which is in essence an open circuit, the Dynon will display a red X over that probe on the screen. Easy way to fault find is to swap the wiring over between the suspect probe and the cylinder next to it, leaving the probes where...

Sounds like your D100 is not mounted level with the roll axis, or there is an internal problem. Simplest way to tell would be to remove the D100, and sit it flat on a floor or bench that you have determined is actually level, with a spirit level for example. Turn the unit on with the internal...

@jnmeade did you find the trouble in the end?

Just out of interest, have you tried modifying the automatic dimming via the setup pages? You should be able to set the minimum brightness there.

The dimensions are on page 15-25 of the install manual I'm sure you only need to use the dimmer panel with the SE, for a HDX you can make your own out of a suitable potentiometer of your choice.

You can put an external ident button in. Pin 20 of the SV-XPNDR to ground, through a normally open momentary switch.

The harness (SV-HARNESS-D37) is not included with any HDX screen I've bought. It's always been a separate item.

Haha! I'm going with "you found the problem"

It might be the cause of your problem. You will get that message if SV sees that the external level button is stuck on during boot up. The fact that it is sometimes activating the AP points to an intermittent grounding of the wire that goes from the external level button to pin 28 of the SV DB37...

Do you have a separate level button still hooked up, as well as the one on the AP controller?

Exactly as Rhino said. I just did this for a customer on the last RV I installed SkyView in. The Dynon intercom has two com inputs. I used a DPDT switch to switch the MIC HI and PTT for the com selected, and two switches to select either or both audio inputs into the intercom.

I would have to think you have some water in one of the connectors as a possible cause. Since you have an EDC and OAT fault, I'd look at the EDC connector wherever you have that installed. Take the backshell off the connector and dry it out. There is also the possibility of the EDC having got...

Can confirm this works as Kaiserman said. I bought a new display for around $100 AUD. 20 minutes of work, and looks like a new one. Couple of fiddly things, be careful with the mylar ribbon cable connector on the top circuit board. If you don't know how to release and reconnect it, look up some...

If ATC can still see your primary return (Mode A), but are missing the Mode C (altitude) data, then it's likely either your transponder or the altitude encoder are at fault. More likely the encoder from past experience. The encoder transmits data to the transponder either over the Gillham code...

support@dynon.com They will help you out mate

The LED backlighting has most probably died in the screen. Get on to Dynon support, they can fix it. I have the same on a customers D180