Search results

Vans seem to supply a standard wiring harness that is built for all options, at least that is what we have received on the last two RV12 builds. So you might find there are plugs waiting for you behind the panel for a knob panel.

This sounds like the issue I struck when I first loaded v16. The fix from Dynon was to physically disconnect the knob panel from the network. Reboot the screen and do a network reconfiguration. Power down the screen and reconnect the knob panel ,reboot and reconfigure the network again. This did...

Have a look in the installation manual I recall seeing them there

The data you are wanting is the USER data Log

I have tried to find the instruction to do one screen at a time but can’t find it but I am sure I saw it somewhere. I do know that when you update the databases you need both running so that they can synchronise the info on both screens. I would imagine if the screens boot up ok you should be...

I would suspect the software is corrupted but thats only a guess. I assume you had only one screen at a time powered on while you did the update and all connected network devices were powered up. I have just carried out an update and it did not require any input at all. Sounds like a call to...

I agree with Rhino based on my latest instal. With my previous setup, not done by me, an A200 radio and PM1200 intercom I had many issues with noise from my Dynon screens. There was a cycling whooshing noise present in the background and no amount of earthing , or rerouting wires seemed to fix...

Hi Rhino that is not quite correct. The 6000B is a mono audio panel and the correct connections are to twist the left and right outputs from the Dynon together and attach them to pin 7. The audio ground ,pin30, from the Dynon should be connected to pin 24 on the 6000B. The screen or shield...

I have a similar issue. When you test the volume of the AOA system on the ground even with the engine started all is fine using the test tones in the audio setup. When you are in the air the AOA system is silent but the other Skyview alerts come through fine. The changes I have made are a bit...

Thanks Don that clears it up nicely.

I noticed a change in performance when I upgraded from the 250 to the 2020. The 250 would aquire a position in the hanger with the doors open the 2020 would not. Pulling the aircraft outside solves the problem but have not seen it taking any significant time to lock on.

When we were doing the flight testing on an RV12 we went through the calibration process which appeared to be working however it would not retain the result. Investigation revealed the tubing from the probe was pinched and blocking the air. All went well once the tube was freed up. One other...

The 472 is a serial device and does not appear on the network

Try swapping the probe to another cylinder and see what happens. If that does not change the result try the probe on another input to the D-180 that way you can eliminate either the probe or the D-180 Input.

The procedure i used to do it was to do the software load on my 10” with the 7” turned off. once the load of the new software is complete you will have to update all the individual components in the system and if you go to the network page you will see an update prompt. Once that is done turn...

Or as suggested in the manual connect a battery charger to your aircraft battery turn on the master switch and leave the Skyview running. It works for me. Just make sure the battery charger produces more amps than the Skyview uses.

Pins 14 and 15 are the important ones and you could use either pins 13 or 16 as the ground. The ground pins are there to provide a ground termination for any of the various sensors connected. when I looked at what had been done on the aircraft I purchased the installer had run all of the black...

X3

Suggest you contact Dynon support they will be able to help

Mine worked exactly as per the installation manual using the autopilot panel and the Ray Allen servo unit. Not sure why you would need to change anything. So I have to disagree with your statement.