Search results

Thought I would close out this saga... Since nobody at Dynon got back to me...decided to change OAT probe, it worked

Exact Message : "EFIS-D10A v2.17.00 (serial #4004)" "EDC-10A v1.05.00 (serial #4152)".

headset test moves heading when close to edc....firmware says version 2.17

tried re-uploading 3 times and then on second attempt got bright red strip ...no EDC which was differnt...on third attempt it found edc...but now has no OAT also on upload got 9 error messages: SPKT regarding chip 4 from chip 1... and one regarding chip 5 from chip 1.. Once I got it loaded I...

Just downloaded new 2.4.3 with firmware included...now get no edc detected and OAT not detected either....was using version 12 and everything fine but thought I might as well get the new stuff....... like an idiot I did not backup and now can't get back to where I was. EDC is connected when I...

downloaded new install program, but when i attempted to download 10A firmware code raw code displayed. it did not down load.... went to plane and checked version though and it says 2.12 seems as though the disconnect while working is getting worse.... can't pinp[oit what causes it...left it on...

yes, with ohm meter...then actually I did entire connection over, just on the off chance I was missing something/

I also have this same problem..same thing...reboot and it comes up, I might have it happening a little more often, did you get it resolved.... I can't unplug the db9 connector as I have a type 1 OAT I have shook wires until I am blue in the face....

Late end to this saga caused by me but the excellent support from dynon got the entire system working....outstanding ;D :) :)

Have type 1 OAT probe.... Reinstsalled software after setting OAT adjustment, Pitch adjustment to zero... then did version check...got EDC not detected... Checked wiring, then asked guy in next hangar to check...then we checked together... all lines to EDC from EFIS Ok, though ground read 18...

Have reloaded twice but didn't know about ther version checking thing... It did say had the latest in efis...will try another reload and use the version check... oat is set right as when I set to type 2 it is not even in ball park... thanks...will see ifi I can get something to change, though I...

Installed EDC behind baggage area..Got latest software, installed with EDC attached Calibrated on airport compass..... Compass reads at least 50 degress off in all directions and OAT off by 40+ degrees... reloaded software and recalibrated ...same results.... anybody got any ideas...seems to...