Search results

I employ EFIS-D100 and EMs D-10a in homebuilt which is equipped to use Mac mini computor. A lot of aviation programs are designed only for Mr Gates/MS so my question is: Can I update both devices with my Mac mini? Thanks, you're great, Ferg Europa mono 914 CSprop

Post 8535: In the interim, I was able to remove the D100 and cannot now reinstall it because of aircraft work. Nevertheless I would prefer to re-charge the internal battery. May I do this by applying 13Vdc to the #1 and #2 pins of the D-sub 37 connector in order to do so? Thanks.

Unless I've missed the cues, may I offer the suggestion that any changes to Installation or Operation of Dynon devices be accompanied by a black line opposite the text lines, to show the exact position of changes? This (you probably know already) is a standard amongst the leading aircraft...

EFIS D100 -WRONG AGAIN. I mixed the holders for my Allen wrenches and now find it IS 7/64ths for the mount. I APLOGISE!

Thanks, I appreciate the reply. I tried 7/64ths and she spun. SO I went to the local tool store and acquired a 1/8th inch which slid into place and did the job.

Thanks for the rapid reply. I am finishing up installing the Efis D100 and I had found the battery voltage below14 Vdc so rigged a short across the ON/OFF switch so that aircraft power would reach the D100 while the switch was of the aircraft. The voltage began to riese ands I was called away...

D100 - My internal battery[0110] suddenly took a nasty dive while I was attempting to chrage up the aircraft battery, so I (eventually) withdrew it. It now registers below 12 Vdc. May I recharge it out side the d100, and if so, what percautuions must I take? Please

I started the project with the EMS-D10 and installed it, and then much later chose and began to install the EFIS D100 unit. There are interactions between the two, which are not considered (naturally) before the second unit is used. One of these is Grounding. I have now grounded both to the same...

When updating EFIS100from computor by switching off the data line have when there is also an EMS-D10A installed. Disconnect both for either task?

I have EFIS100 and EMSD-10A and the above BU-33 which I wish to connect to the EFIS. The BU33 is of course supported by USB A and the EFIS by RS-232. Can I connect these to provide position to the EFIS? If yes, how?

>:( I am beginning the installation and on page 2-14 CHT SENSORS, para2, says: "Connect either end of one of the resisitors to the +5V Excitation Circuit (pin 18) and the other end to the wire connecting the left CHT sensor to pin 4. Repeat this with the right CHT sensor." I presume this implies...