Added a Heated Pitot & Connection to EMS

[rfazio1951]

I added a heated pitot to my RV-6. I also ran the indicator wire to my EMS pin 10 as contact. I went in and added the sensor as a contact and put the contact indicator on the engine page. I can't seem to get it to work. I went in to the EMS setup page and I can see the contact is working. When I put the pitot on I see 5 volts on that pin and when I shut it off it goes to zero. But no indication on my contact indicator on the 100% page? What am I doing wrong?

 

[Raymo]

Richard,

I suggest running through the setup again that begins on page 15-1 of the install manual, rev AD (though the the revision at the bottom of each pages says AC).

 

[rfazio1951]

Ray,

     Thanks for the response. I did use the install manual for the setup. So I went out to the airport and went in and checked it again, line by line. I had it wrong. It now works, thanks.