I am testing the canopy wiring and setup before installing. I have a microswitch attached to pin 22. It is sending 12 v to the pin when the switch is open. To the same switch output I have a small warning light, recieving the 12v. The light is grounded seperatly. In the Dynon setup I have pin 22 configured as defined on page 7-81 and 82.
When I press the switch the light goes out but the widget on the screen does not change. It should turn green for no voltage. Whant am I doing wrong ?
When I press the switch the light goes out but the widget on the screen does not change. It should turn green for no voltage. Whant am I doing wrong ?