Search results

That is what I did. Borge

I have tried to connect via alternator but had problem with the charge light not working with this setup, i therefor connect to the magneto. There is an output from the Rotec electronic ignition giving 5v but the EMS does not read this signal. I have installed an 30kohm resiston to this lead and...

I have bought Rotec electronic ignition for my Jabiru 2200 and by connecting the lead (tachometer output) from ignition to my EMS nothing happens, anybody familiar with this problem? Would it be possible to connect the orginal mag. pickup standard Jabiru to the EMS? :) Regards Borge

I updated the firmware to V5,3 before I installed it in the plane. Regards Borge

I have installed an EFIS 100 with the remote compass in my Jabiru 170 but have problems with numbers in the EFIS 100 fluctuate. The remote compass is installed under the left seat with no electric cables close to it. Anybody that have experience the same problem? Thanks Borge :)

I followed the recommendation and connected the EMS tachometers left wire to one of the alternator wire but then my charge light disappeared. then I connected the EMS to left and right magneto through an 30k ohm resistance. Is there any chance for those to connectors to be short circuit in the...

The wiring is correct and the amp bar shows + amp when throttling up the only problem is the amp. bar is jumping up and down. Regards Borge :) Anybody who can help here? Borge :)

This is an Jabiru 2200 engine installed in a jabiru 170 epoxy fuselarge thanks Børge

The amp. bar on my EMS is fluctuating, is that normal? if not could it be sorted by installation of an resistor (size) :)

When I power up the EMS there is a click noise every 5 sec. Is that normal? Regards Borge :)

What size resistor is that? Regards Borge :)

:)I have the left wire from ems connected to the alternator on a Jabiru 2200 engine. The tach. works fine up to 15-1600 rpm but then start jumping up and down from 1600 to 2500 rpm. Would an resistor sort this problem? (if so, what size) Regards Borge

I`m in process of installing a Dynon AMP shunt Specs 0-60A. And I wonder which end of the shunt is AMP high and which is the AMP low one side of the shunt is marked 40A and the other end is marked 40mv. Thanks Borge

When connecting the tachometer sensor wire to the alternator wire how many pulses should be entered in to the EMS set up? Thanks :) Borge

Jabiru 170 owner Where is the best place to intall the senso on a Jabiru 2200 egine? Should it be installed between the engine fuel pump and the carburettor? Regards Borge :)