Search results

Thanks for the replies. My question was do you get an audio alert. I know with some widgets that there is no associated audio alert on the Dynon system so that was the reason for my question. I think I was quite clear that it was the sensor I was choosing between, Aithre, Flight DataGd-40 and...

A question on the Aithre Shield EX 2.0 installation as I haven’t found the answer in any other posts. When the sensor is installed and set up with the supplied sensor file does the Skyview system give an audio alert when the needle goes into the red zone? Just trying to choose between the...

Check it with a hand compass. You will soon see if there is any major magnetic interference. My 6 does not have a remote mag I just use the one in the adhrs which is mounted behind the baggage bulkhead.

If it’s not working perhaps an email to Dynon may help.

There is some confusion here. Both of my Skyview screens have a db37 connector on the back. The OP s board is a distribution board that takes one 37 pin connector and distributes it to two Skyview screens avoiding the need to splice wires together for the serial ports etc. It is not a network...

Not quite sure how a 25 pin hub will work with a Skyview system that used a DB37 37 pin main connector.

Think you might need to configure the network if all is as it should be electrically. Go to Setup/system setup/Skyview network setup and carry out a network configuration. This will go and look for all the devices attached to the network. As far as I am aware the network is not plug and play.

Not sure what aircraft type you have but Vans released a Service Bulletin about this last year.

I leave the autopilot power turned on all the time so I guess that will reduce the chance of an internal breakage. I have never flown an aircraft yet where you have to completely power off the autopilot for any particular phase of flight. I am happy to follow Dynons advice , installation manual...

I have used a Tyco W31 switch circuit breaker which combines both functions. Seems to do the job ok.

Revision aj the section I posted was cut from that page. No mention of traffic or ADSB.

Hi I wasn’t aware of the Slingshot feature but it appears it still only copies to the USB stick. Aviation databases and charts can also be downloaded over Wi-Fi from some third-party apps – such as Seattle Avionics FlyQ – directly to a USB drive inserted in SkyView display. This eliminates the...

Page 7-34 of the classic pilots guide. VS REQ'D OPTIONS:” Use these settings to configure the Vertical Speed Required to Destination Info block on the map. Select the distance from and the distance above the final waypoint (i.e., destination airport/runway) in the Flight Plan and SkyView will...

You are not wrong the file loading option only looks at the USB unless I have missed something to. flight plans can be uploaded by wifi but they are initiated from the iPad.

You will need a WiFi dongle.

Jake my last CHT probe experience was an erratic CHT reading. I have replaced 3 probes in the past. I transferred the probe to another cylinder and the problem transferred. I then swapped to the OLC connector based on other’s recommendation and the problem was resolved. In the last 40 hours...

My thoughts were that it was not the actual spade connector itself but the crimp on to the sensor wire that was causing the issue. I don’t know if the types of wire and crimp involved could be causing the issue but it seems strange that with all the spade connectors used in the automotive...

+1 from me for the olc connectors. I was having constant problems with CHT readings. I bought new probes but the problems continued. I replaced the spade connectors with the olc connectors and no problems since.

The current installation guide AO refers to both the EMS220 / 221.

It’s not too bad a process particularly if you are still covered by the warrant. I am in NZ and have been involved in the return / repair of three units.