Search results

Thanks Ray, I will revisit the POS diagram on the Ray Allen site. Understand about flap position...I can look out my door and see where they are at! Trim I cannot, and might like to be able to set a neutral or take-off setting during checklist prior to start. Something to think about anyway...

Thanks Ray, re: Ray Allen servos...I meant to say that I will or may need the 5V for my position sensors output of the trim servo and my position sensor for the flaps.  Does that sound correct?  The servo does indeed take 12V for power, but I am bypassing any indicator typically used (i.e.; the...

Thanks for the replies...understand about the 12V for the FT-60's.  The Dynon manual is clear regarding acceptablility of using same power source and ground for like required voltage sensors.  My follow on question would be this:  Does one typically just bring the EMS provided voltage wire thru...

Starting to wire up my engine sensors to the EMS 220 module.  The CHT and EGT seem straight forward.  For the other sensors; Red cubes FT60 (2), engine oil pressure, fuel pressure I need to provide power and ground for them to output signal into the EMS 37 pin harness.  Can I utilize the aux...

Here is where I ended up mounting by top antennae(s).  Gives me 44 inches from the VHF to GPS 2020 and 14 inches from the ELT to the GPS 2020. Thanks for all the discussion on the forum!! Dave

All, Thanks for the discussion.  The issue Steve referenced was my main concern...discussed in depth on the RV site a couple year ago my some builders and the exact same issue Dynon just addressed in reply #5.  My ELT is indeed a more modern one (ACK model E-04) along with GPS 2020.  Between...

Dynon...any thoughts on this question? Thanks!

I have read the posts, but would appreciate a forum opinion or Dynon input. I would like to mount the the puck on top of the fuselage. I can achieve over three foot separation from my VHF antennae, but would place the puck within a foot of my ELT whip.  Typically, the ELT would not be an...

Thanks for the reply... :)

Hi Dynon Starting to route my servo and ADHARS network harnesses from the back end of the aircraft up forward to the panel.  In addition; need to route flap power, pitot power and comm RGA400 cable from the back as well. (1) Is it OK to "bundle" the servo and ADHARS harness together in the...