Search results

In the support program, select your product from the first menu, then on the second menu, select "configure checklists/data panels." From there, it should be fairly straightforward. Definitely retrieve your existing lists from the unit as a starting point. The help button on the main page of the...

Our products can not monitor fuel level via frequency. As long as there's a good signal, resistive and voltage outputs are basically the same in terms of available accuracy.

There aren't any settings that differentiate pilot vs pax sidetone, at least with the Dynon Intercom. For audio panel-based installs, there may be settings on those devices, but I doubt it. Point of clarification: are you hearing no audio through the headset at all on that side? Or are you only...

Give our support team a call at 425-402-433 or email at support at dynonavionics dot com when you have a chance. We'd like to learn more about this. But fundamentally, you're correct - the currents that flow across that connector are suitable for the connector.

Yes, you can change the name via the sensor input mapping setup. Page 7-74 of the installation manual (as of 3/19) starts the description of the general process for changing them.

Yes, but not on the D37 connector. The "extra" two thermocouples that exist on the -220 are repurposed for CAN and for propeller control units on the -221. You can, however, use the regular D25-based thermocouple inputs as are normally available for EGTs/CHTs on other engines. Refer to the...

Check the traffic display settings under SETUP MENU > TRAFFIC SETUP.

The only thing that comes to mind is to check the ethernet cable (or try another one, any garden variety ethernet cable is fine for testing). You might try removing the aviation/obstacle databases from the displays manually to see if that changes anything. Beyond that, you'll want to get in...

One troubleshooting step is hitting the "reset" combination of keys, which are buttons 1,2,5 simultaneously when power is applied but they're not booting up. Does that change anything?

I'm not sure what type of sensors the JPI systems utilize, but, the CHTs will work if they're a type J thermocouple. The EGTs will work if they're type K thermocouples.

The bottom band is only supported on HDX. The UI/UX is substantially different between Classic/Touch and HDX, so we can't easily port them between the systems. We do not have plans to add the bottom band to the Classic/Touch series.

It seems that the cal page shows you what the ADAHRS are up to, but the magnetometer is the thing actually being calibrated and used after the cal is done.

Are you also talking to our support folks about this? I heard some chatter around the office...

The D180 only has one shunt input.

What GPS source are you using? Is this on the ground or in flight? Pitch and roll should be completely fluid, while the actual position viewpoint is updated as your GPS does. with the SV-GPS-2020 or SV-GPS-250 this is 4-5 times per second. The overall effect should be smooth. If you're on the...

Give our support team a call at 425-402-0433 or an email at support at dynonavionics dot com for help with this issue.

When the 912 iS is selected as the engine type, there are two additional widgets that you can place on the layout. So basically, go to EMS SETUP> ENGINE INFORMATION> and verify that ENGINE TYPE is set to "ROTAX 912iS". Next, go to EMS SETUP> SCREEN LAYOUT EDITOR> and select one of the layout...

Hi Steve - The best way to troubleshoot this from here is to get in touch with our support team at support at dynonavionics dot com.

Not quite, but same effect (second amps probably doesn't log). Certain sensors that the system considers special (like amps) don't log when there are multiples of them. I don't believe that that logging behavior has been changed.

The HS34 can adjust the bugs (heading and altitude), which are the autopilot targets. But it has no way of changing the autopilot modes. It just doesn't have the buttons for it.