Search results

  1. Speeddog8

    Does the Skyview has airport map?

    I too would certainly vote for the airport diagram to automatically appear when on the ground. That’s a really nice feature that helps eliminate pilot workload.
  2. Speeddog8

    Does the Skyview has airport map?

    I’ve been using an iFly GPS for years now. It has a map feature that offsets the depiction of your aircraft’s position on the screen dependent on the direction the aircraft is flying (in North Up View). The reason for this is to allow more viewable “real estate” AHEAD of your aircraft. I...
  3. Speeddog8

    Comm Volume too low

    I’ve noticed that when I use the Dynon Com, I have to set the volume lower than I want it to be in order for there to be sufficient clarity. Is this the same problem others are having? I’m using a Garmin Audio Panel and a Bose A20 headset.
  4. Speeddog8

    PTT Increases EGT

    I tried the in-line harness filter as well but it did not solve my EGT, CHT spikes that occur while transmitting on the Dynon Com. They wouldn’t bother me if it weren’t for the fact that every time I key the mic, I lose my lean find setting’s. I have a GNS-530 in there as well that will...
  5. Speeddog8

    D-180 Timing Advance using Lightspeed's new "L2E"

    I have the same question. I too would like to know if the L2e will display Lightspeed timing advance (for a dual EI system) onto a D-180. The L2e installation instructions mention scaling the input on the EFIS (for example: 2.5v = 25 degrees advance timing). Is this possible with the D-180...
  6. Speeddog8

    Dual remote compass

    I have a D180 and D10A in my Glasair running their own remote compasses. I have them mounted just aft of the baggage compartment on a shelf. The two units are approximately 18" apart from one another and I've never had any issues with them. Hope this helps.
  7. Speeddog8

    D 180 artificial horizon out

    Thank you for your response. I spoke with your representative. I'll get it sent out to you guys for repair. Chad
  8. Speeddog8

    D-180, Disappearing data when I key mic

    Jake, Better late than never,,, right? I never did "find" my problem, but the problem seems to have gone away for the most part. Occasionally, I'll key the mike and my TruTrak autopilot will pitch up or down slightly. Doesn't seem to do it all the time, but the Dynon EGT and CHT issue...
  9. Speeddog8

    D 180 artificial horizon out

    I've been running a D180 and a D10A for backup in a Glasair for about 8-years.  The artificial horizon on the D180 has begun to lag far behind the D10A (particularly in roll) during normal maneuvers.  Any idea what the problem could be?  One additional issue with this D180 is that when...
  10. Speeddog8

    Lightspeed tach input into Flightdeck D180

    Thanks Guys,,,, I'll give it a try. If no success, I'll buy the transducer from Vans and be done with it. Would you recommend I connect one ignition or two to the inputs on the Dynon?
  11. Speeddog8

    Lightspeed tach input into Flightdeck D180

    I'm about to install dual Lightspeed ignitions (two Plasma III systems).  Can anyone tell me whether they've had success in getting the Dynon D180 to accept the tach outputs of the Lightspeed units and if so, what settings did you have to enter into the D180 to make the tach read correctly? ...
  12. Speeddog8

    iFly 700 connected to HS34

    I had apparently selected ALL of the various NMEA sentencing available on the iFly 700 rather than only the sentencing that Dynon recommends. The switch appears to be working perfectly and the HSI needle is swinging as expected. Thanks for the help guys. Chad
  13. Speeddog8

    iFly 700 connected to HS34

    If I recall, the NAVSRC button just switched it between GPS, VOR, and Compass. The 396 has been working fine with the HSI, but now I've added the iFly into the mix with the switch. I'll monkey around with it a bit more this weekend to nail down the issue. I'll also check the settings on both...
  14. Speeddog8

    iFly 700 connected to HS34

    I got the switch installed and it appears to be switching GPS feeds to the HS34 just fine between the iFly and the Garmin 396.  I have a new question however (go figure). I haven't flown with this setup yet.  I had the Garmin tuned to an airport north of my position and the iFly tuned to an...
  15. Speeddog8

    iFly 700 connected to HS34

    I'll try installing the switch first as I think that would be a simple, one step means of switching back and forth, but if it doesn't work, I'll try your alternative method. Thanks!! Chad
  16. Speeddog8

    iFly 700 connected to HS34

    One more question. I'll have a switch that switches between the Garmin 396 and the iFly700 providing data to the HS34 and to the TruTrak autopilot. Will I have a problem with the HS34 or D180 if I'm switching back and forth between the two GPS feeds to the HS34? The primary reason for having...
  17. Speeddog8

    iFly 700 connected to HS34

    Thanks Dynon. I'll omit the return line then.
  18. Speeddog8

    iFly 700 connected to HS34

    Thanks so much Guy! By the way, why does the HS34 installation instructions want you to connect the Data out line from the HS34 to the Data in line to the Garmin 396? What purpose does it serve?
  19. Speeddog8

    Fuel Pressure Display

    Thanks Guys. I'll see if I can configure something that makes me happy.
  20. Speeddog8

    iFly 700 connected to HS34

    Has anybody connected an iFly 700 GPS to the HS34? I already have a Garmin 396 connected to the HS34, but now I've added an iFly to the airplane and would like to be able to switch between the two. The HS34 instructions for connecting the Garmin includes both a Data in and data out connection...
Top