Search results

Thanks for your reply....however, I was asking about adding additional EGT probes and your response seems to be referencing CHTs??

It is my understanding that the D180 will support up to 6 EGTs.  I have 2 EGTs presently connected in my Rotax 912 (cyl 3 & 4).  I wish to add 2 additional EGTs probes to Cyls 1 & 2.  I have gone into the D180's configuration via - EMS, MORE, SETUP, EGT.  In the EGT window, I don't find the...

Oh come on........ >:( Where is the G reading displayed on the D180?

Is it possible to check the G reading of the D180 without sending it in?  I believe my D180's G setting has gone bad once again.  >:(

Jake J..... Thank you for your suggestion.  I reconfigured channel 1 to show Input Icarus ALT and my transponder now shows a pressure altitude!  I left all other fields unchanged. Thanks again.  :)

No, it has never worked.  I went into the config of the GTX327 and found RS232 Channels 1 & 2 set to off. I believe it says output and that was set to ICARUS. I'll check again tomorrow.

Hello, I have a RV12 with the D180 avionics package. My transponder (GTX 327) does not show the pressure altitude.  I've checked the D180 configuration and it shows Format 4. I believe this is correct. Assuming the wiring harness is correct, any suggestions to get Pressure Altitude to show on...

Well here goes.......don't beat me up.  I sit behind a D-180 with a Garmin 496 and AP74 in my RV12.  I was wondering if it is possible to connect a Skyview to the D-180 using DSAB and using all the inputs the D-180 has to input into the Skyview?  Do wiring harnesses exist for this type of...

Hello, I have a Dynon D180 in my RV12 and I want to utilize the AOA capability of the D180.  What is the part number of the connector which connects to the back of the D180 for ordering and also what size plastic tube do you use?. Thank you, Steve

Thank you!  I just couldn't find it in the book.

Hello All, does anyone know how to adjust the Hobbs Meter readout on the D180? I recently had some work done on my unit and when it was returned, I didn't feel my settings had been reloaded. After flying a couple of hours, I reloaded my backed up settings (not knowing Hobbs is one of those)...

Item returned I received my D180 back from Dynon on 9/19/11 with no information provided on what they did to fix the issue. :'(

I was asked by Dynon to return my D180 for service (which I did). Support mentioned that the G-loadmeter needed to be adjusted. Hopefully, a more detailed explanation will be reported here for everyone to view.

I performed a calibration setup again and the setup was successful.  I understand why the aircraft will continue to try to climb when attempting to reach an altitude above its present level.  However, I don't understand why it climbs when the assigned altitude is below the aircraft.  Calibration...

My ground test resulted in the following:  With the A/C on the ground at 500 msl, I set in 2000 ft for an altitude and engaged the AP.  The elevator moved to show a FULL climb deflection and the pitch servo reached the limit and you could hear it making a slipping sound when it reached the...

I'm just starting to test out my AP in my RV12, and have the following issue/situation that I would like to get some suggestions or ideas on.  Here is the situation.....I'm flying level at 2500 msl and dial in an altitude of 2000 msl.  I now turn on the AP and the aircraft begins a CLIMB at a...