Search results

Slow response to climb with bugged altitude. Starting with the install of V16.0 or so. I've noticed that when using AP, I bug an altitude and,(my default climb rate 800ft/mi) the aircraft climbs within 1000 to 1500 ft of bugged altitude then the bugged altitude shown above the altitude indicator...

Thanks for the great info! My interest is a bit different. My fuel flow reading on the panel reads .2gal/hr without engine running. How do I make this zero. I have adjusted K value from one extreme to the other. No change.

FT-60 K factor changes do not change the indicated flow. True fuel output is higher than what is displayed on HDX. I have adjusted the K factor from 68000 to higher number in hopes of matching displayed value to actual output. No joy! All help is appreciated. Thanks!

Installed cowl flaps on RV6. Would like to have cowl flap widget on HDX display that flashes when flaps open. Does this go to EMS system or Efis system? Thanks!

Looking for a trade of Dynon vertical knob panels for horizontal panels. These panels are in perfect condition. Bothe AP panels. I will pay shipping!

Is there any way to remove the ADSB data display square that shows on the screen. The adsb info block uses too much area. I would like to eliminate all of the data fields other than ADSB- online. Thanks

The 10 inch classic non touch is still available. This is not the SE model. This display has all of functionality as the touch system minus touch feature.

Up for sale will be one 10 inch SkyView touch and, one 10 inch SkyView classic. Both displays are currently being used and, running with the SkyView V17 software. Displays have about 400 hours on each and are in perfect condition. Displays will be removed this coming weekend. Each will come with...

Does Dynon have 10 inch HDX’s to ship? I’m in need of two!

Bugged altitude cancels. When using AP I enter new altitude then press vertical speed up. New bufgged altitude is 5500. Panel indicates 700 f/min up and the climb begins. Within a few seconds the new bugged altitude disappears. Aircraft is still climbing. bugged altitude no longer displayed. If...

Thanks for info !

Reading thru the new inflight auto pilot tuning guide I see instruction to tune the roll guidance with pitch control turned off. How does one do that! Thanks

I would like to reinstall an older version of software. How do I get 16.0.1? Thanks in advance!

I received my backup AHAHRS from Dynon after a repair. This is the 201 backup unit. Installed per instructions. Immediately received pitch error message. 201 unit does not agree with 200 primary ADAHRS! Not sure where to go with this one. Units are mounted with Dynon stacking mount bracket...

Thanks! Already updated and force loaded. No change.

Struggling with ADAHRS issue. I have dual ADAHRS (200 s/n 09383-201 s/n 05565. The backup (201) ADAHRS fails after a engine restart only. It never fails on first flight. If landing for fuel the backup shows failure on restart. ADAHRS source selection shows alternate ADAHRS is disabled. Moving...

Dual SkyView touch with dual ADAHRS. Recent warning states the secondary adahrs is offline with errors. When reviewing configuration the secondary ahadhrs shows red X across its position. It does show on the network config screen as installed and ready. I received information from Jeff at Dynon...

Running dual ADAHARS with a dual sky view screen setup. Periodically one of the ADAHARS drops out. Message sez : 201inop- numinous errors. If I view both ADAHARS on screen I have a red x over ADAHARS 201. When I go back and check skyview network status it shows adahars 201 online and ready. Any...

Thanks for your reply. Already replaced connectors plus pulled wires from D-sub connector and, replace new D-sub pins. Open to any and all ideas!