Search results

With a 7" screen, I would like to have more real estate for the PFD and moving map. That's my rational. Rather than mimicking the entire 20% view along the bottom as you mocked up, an option could be allowing for a smaller space along the bottom that allowed for a few critical horizontal bar...

How about the ability to put engine monitoring as a strip at the bottom of the screen?

I have the same "issue" and suggestion #4 is interesting. Would this reverse the effect of the pot- ie clockwise rotation would now dim the screen? Craig

Can we get a sneak peek at 7.0 features? Thanks in advance!

Hi All, Trying to decide on roll servo replacement on my flying 6- under seat vs. wing. I know that proponents of wing placement often cite unwanted pitch inputs as a risk of under seat placement. This seems possible given the mechanics of the control rods BUT what I am interested in is...

Hi all, I currently have both network ports in use for my ADAHRS and EMS. I am adding A/P servos and I was planning on putting a hub near the pitch servo to share the network cable that connects the ADAHRS and minimize the new wiring I need to add for the servo. It occurs to me though that I...

I checked and my 327 firmware is 2.09 so it either needs to be running 2.10 or I have an issue with my TX line from it to the SV.

Nothing.

Do you recall what firmware level you upgraded from and to? Craig

I get an X at the top of the screen. I have my GTX327 receiving altitude information from my Skyview and of course have TX out of the 327 to the same Skyview serial port. I set the Skyview to expect GTX327 IN and set the GTX to REMOTE for output. I'm currently running 5.1. Thanks, Craig

No problem!! What version were you running prior to the upgrade? Dynon says most people don't need 4.0.1 but if you went from 4.0 to 4.0.1 and that fixed your problem, I might try it. Dynon support, Any reason I SHOULDN'T upgrade? Craig

4.1 of what? Since you'd have ot send the 327 in for a firmware update I assume you mean 4.0.1 of the Skyview firmware? I have the same issue with my 327 and am running 4.0 Skyview firmware.

Re: Erratic RPM on one mag-Solved I hate to admit it was the obvious but wanted to share for the good of the next person... ;) Loose p-lead connection at the mag. Tightened it up and RPM is rock solid. Thanks to all for the feedback. Craig

I'm still having erratic RPM readings but only from the left mag. I've increased the resistor on that line from 30k to 100k ohm. Zero improvement. If I run only on the right mag, the RPM is stable. On either the left or both, RPM fluctuates RAPIDLY by 1500+ RPM. Anything else I can try...

Ran the calibration and have not seen the issue since. I'll keep an eye on it. Looks like 2 out of 3 resolved!!! Craig

Dear Dynon Support, I'm having three issues which I had thought were unrelated but now I'm wondering. All three seem RPM related only exhibiting issues above ~1000 rpm. Turning off the alternator or switching to either mag has no effect. 1) Serial port errors on all three ports in use. The...

I seem to be experiencing the same issue. It started about 4 months after installation so my assumption was that my resistor installation was not robust so I replaced them with a new setup - no change. I have not tried checking to see if it's tied to one mag. Have you had any luck fixing...

It is Unswitched. Sorry for the repeated misstatements. ::)

The switched inputs are specified at 500ohms, this is compatible with the Skyview output? I'd much rather use the switched output since I'm already using the entertainment input. Regards, Craig

Support, Can I connect Skyview audio out to the Unswitched inputs on my PS Engineering PM3000 intercom or do I need to use my entertainment input? Regards, Craig