Search results

The single widget on the EMS pages should show both axes (or all three if installed) as described. Ae both GP inputs named correctly? (IE, TRIM AILRN and TRIM ELEV?). However, the EFIS page widget (overlaid on the actual PFD) is elevator only.

Hmm, not sure on this one. Try clearing your data logs to reset what is being written. Are those EGTs actually showing on the screen correctly (that would indicate they're configured correctly).

The non-muting inputs are not individually adjustable. As others have said, a variable potentiometer could do the trick here to attenuate the inbound signal.

There is an EMS widget that can be displayed. It's a contact type widget (but in the "info item" list for some reason) and shows on/off status.

Yeah, there's something going on here. We'll be upgrading the forum software soon - hopefully this hangs on just long enough.

We're a bit backordered on ADAHRS right now. Give our sales team a call at 425-402-0433 or an email at sales@dynonavionics.com for more personalized assistance with this.

It applies to all SkyView systems. It depends on the GPS receiver you have, not the model of SkyView.

It isn't currently possible to move the slip ball. The slip indicator isn't adjustable. The ADAHRS mounting should be adjusted to ensure that it is aligned.

One thing to test this - disengage the AP when it's fully trimmed out and not commanding any trim (ie, it's happy). Is it in trim? Know that the auto-trim endeavors to fly the airplane in trim, but that is necessarily a range where the residual force on the servo is "low enough". So one thing...

Yes, please contact our support team. We believe some early GPS receivers are affected by the GPS rollover that recently occurred.

Is the D180 new or just new to your aircraft? In any case, performing a zero pressure calibration should help calibrate the low IAS indications.

Acually, we think this is due to the recent GPS rollover issue. Please contact our support team at 425-402-0433 or support at dynonavionics dot com for more help with this issue.

I'm not sure what happens to the serial out while you're downloading (checking). My guess is that it either continues as it does or ceases transmitting during the export. Lack of a data stream from SkyView probably wouldn't cause it to alarm though.

In simplified mode, there is not. But in expert mode, you manually set the intercept angle with your HDG or TRK target.

Sorry about that - you caught us while our forum-minders were away at SnF and Aero. Note that compatibility is covered in both the installation guide and on the ordering guide on our website.

Either this one or this one work with the D180. The former can connect through the EDC-D10A remote magnetometer or an EMS general input pin, while the latter can only connect through an EMS general input pin.

The -470 uses a different format for traffic internally which currently makes it incompatible with Foreflight. We don't currently have a plan to address this, because it's a pretty huge change for a comparatively minor feature. We also have what we think is an attractive upgrade path to the...

Couple of question: Do you boot them at the same time? Do you have backup batteries on both?

Won't be in the nearer release (which more primarily supports certification changes), but will be in the next feature release. We don't have a date estimate on it yet.

There's a setting on SkyView that allows you to tell it that there is a non-Dynon ADS-B out device installed. That lets SkyView know that it should display traffic that is sent over ADS-B. Even today, you'll be able to see 978-equipped ADS-B Out emitters when you're near them, but you won't get...