Search results

  1. P

    FT-60

    FT-60 K factor changes do not change the indicated flow. True fuel output is higher than what is displayed on HDX. I have adjusted the K factor from 68000 to higher number in hopes of matching displayed value to actual output. No joy! All help is appreciated. Thanks!
  2. P

    Cowl flaps On HDX

    Installed cowl flaps on RV6. Would like to have cowl flap widget on HDX display that flashes when flaps open. Does this go to EMS system or Efis system? Thanks!
  3. P

    want to trade

    Looking for a trade of Dynon vertical knob panels for horizontal panels. These panels are in perfect condition. Bothe AP panels. I will pay shipping!
  4. P

    HDX display choices

    Is there any way to remove the ADSB data display square that shows on the screen. The adsb info block uses too much area. I would like to eliminate all of the data fields other than ADSB- online. Thanks
  5. P

    Skyview displays for sale

    Up for sale will be one 10 inch SkyView touch and, one 10 inch SkyView classic. Both displays are currently being used and, running with the SkyView V17 software. Displays have about 400 hours on each and are in perfect condition. Displays will be removed this coming weekend. Each will come with...
  6. P

    Skyview HDX

    Does Dynon have 10 inch HDX’s to ship? I’m in need of two!
  7. P

    Auto pilot bugged altitude cancels.

    Bugged altitude cancels. When using AP I enter new altitude then press vertical speed up. New bufgged altitude is 5500. Panel indicates 700 f/min up and the climb begins. Within a few seconds the new bugged altitude disappears. Aircraft is still climbing. bugged altitude no longer displayed. If...
  8. P

    auto pilot tuning

    Reading thru the new inflight auto pilot tuning guide I see instruction to tune the roll guidance with pitch control turned off. How does one do that! Thanks
  9. P

    Skyview software

    I would like to reinstall an older version of software. How do I get 16.0.1? Thanks in advance!
  10. P

    ADAHRS issues again!

    I received my backup AHAHRS from Dynon after a repair. This is the 201 backup unit. Installed per instructions. Immediately received pitch error message. 201 unit does not agree with 200 primary ADAHRS! Not sure where to go with this one. Units are mounted with Dynon stacking mount bracket...
  11. P

    Backup ADHRS shows failure

    Struggling with ADAHRS issue. I have dual ADAHRS (200 s/n 09383-201 s/n 05565. The backup (201) ADAHRS fails after a engine restart only. It never fails on first flight. If landing for fuel the backup shows failure on restart. ADAHRS source selection shows alternate ADAHRS is disabled. Moving...
  12. P

    Backup ADAHARS drops out

    Dual SkyView touch with dual ADAHRS. Recent warning states the secondary adahrs is offline with errors. When reviewing configuration the secondary ahadhrs shows red X across its position. It does show on the network config screen as installed and ready. I received information from Jeff at Dynon...
  13. P

    ADAHARS drops out!

    Running dual ADAHARS with a dual sky view screen setup. Periodically one of the ADAHARS drops out. Message sez : 201inop- numinous errors. If I view both ADAHARS on screen I have a red x over ADAHARS 201. When I go back and check skyview network status it shows adahars 201 online and ready. Any...
  14. P

    EMS- lost signal on #1 EGT

    Two year old fully functional Dynon complete panel system is RV6A. Last week #1 EGT stopped working. #1 EGT read out has a red X on it. Absolutely no data. The attached picture is from the EMS setup menu. Replaced #1 EGT with new sensor. No change! Anyone have Thoughts on possible resolution...
  15. P

    Auto Pilot disappears.

    Dual Skyview screens with knob panel and, autopilot panel. Today after starting engine I noticed that the AP panel ws not functioning. The AP function on the Skyview buttons was missing as well. Trim function is wired through AP panel. Trims works. Checked setup menu for Network devices. AP...
  16. P

    Auto trim will not function

    I have dual Dynon SkyView screens with the knob panel and, the auto pilot panel. Everything works as advertised except auto trim. Thinking it might be the panel I exchanged it with another new AP panel. Still not working. Current manual trim is setup through the AP panel. Manual trim works as...
  17. P

    V16 definitions

    After installing V16 software, in the auto pilot setup screen for roll control, I see new roll control points. CDI gain, CDI dot gain, XTE gain, and XTE dot gain. I can't find any documentation that explains what they and how to adjust. Thanks in advance for any help!
  18. P

    Sky view WiFi

    Does sky view T or classic have the capability to connect to iPad for traffic view? Like the system but would like to have traffic on separate screen. Thanks I’m advance!!
  19. P

    Auto pilot knob panel disappears

    when Starting up the aircraft I notice that I don’t have the autopilot button on the skyview panel. AP button on autopilot panel is inop As well. I check the system status and, it shows that the autopilot panel and servos are installed and good to go. Servos pass calibration. If I shut down...
  20. P

    AP panel issues continue!

    I have been working thru AP issues for the last two months. Issues that included pitch control issues and constant roll slip and pitch slip indicators. Dynon support helped resolve many of the issue. One additional issue that just came up is: Each time I start up the plane the AP panel is not...
Top