Search results

Yeah me too but I was only referring to the probes :-) BTW, it was great to speak with you the other day & I trust the ADAHRS issue will be resolved soon. Regards, Jake J

Jay I have made several posts re the Egt/Cht connector issues - I say yet AGAIN, most issues were/are with the terminal on the probe side ( not manufactured by Dynon) & some are with the crimping done by the builder.   The push on connectors themselves are ok but not as good as amp.   I think...

YtC Try an 100K ohm resistor (yeah, I know the manual doesn't call for one but it won't hurt) , this has worked for me in most Jabby installs ;) Jake J

maybe a dynamic prop balance check is worthwhile ? Jake J

Larrynew Go with the nylock nut, it's standard practice for most bolts in shear applications & autopilot pushrod to bellcranks as well. Jake J

A Dynon 'hub' would have worked too ;D Jake J

Steve May I suggest you tweak the airframe up first ie get it rigged and trimmed (skid ball in centre at normal cruise speed) so that the a/pilot doesn't have to work against airframe loads, then adjust the settings as required - this applies to all autopilots  ;) Jake J

Pete The capacitive senders are much more reliable & accurate, mostly. Jake J

Several thousand hours ? Really ? Jake J

Randall Mounting the SV at an angle like that works just fine - mounts can be done in all sorts of manner, you just need to work a design that suits you. Jake J

You're going to trash a good system worth thousands & keep a cheap handheld :-? I'm glad you're not an accountant.

Are you using Dynon supplied network/ autopilot cable & did you make some of it ? Jake J

Yep, it's called a pitot/static test box, all avionics shops have them ;) Jake J

Jim I'll pm you ;)

I have recrimped the faston connectors on all senders since this started and it didn't make any difference. That's only half of the equation ;) did you check to see if the pins were fully in place at the dsub connector ? Try doing a search of this topic - much has been said about this, it's...

Jim, Simple answer is yes the SV Transponder meets the requirements if installed correctly & pass AD/RAD/43/47 - I've installed many of these & call give more info if needed, just pm me ;) Jake J

I have sent you a pm :) Jake J

Just a little reminder to others, & I figure Ron has done this already, please do a backup of your system settings before updating anything ;) Jake J

Try reversing the 2 small ammeter sense wires ;) Jake J

No problem at all ;) Jake J