Search results

I got an error message, transponder failed. This went away once the GPS came back on line ? Eddie

I have a 3 year old Skyview installation with Dynon supplied GPS. This is also the only GPS source for the Skyview. Last week the GPS went off line taking the transponder with it. On landing I moved the wires around near the base of the GPS puck and it came back on line and kept working for...

One more point that everyone should consider. Unless you have PocketFMS or Jepsen data you will not be able to navigate to any of the airports displayed on your Australian hybrid maps. Cheers Eddie

Ok once at this point in the menu how do we load the new map source? This whole process is not very obvious, and honestly just a little confusing? Regards Eddie

Out of curiosity why is this process completely different to what we did previously to load other vendors map data such as pocketFMS?

Fantastic , looking forward to both Version 13 and Australian maps on the SkyView Cheers Eddie

Hi Guys, One of your announcements alludes to the ability for users in Australia to buy map subscriptions from OzRunways, when will this be available as I'd love to upgrade to charts that make sense in this part of the world? Cheers Eddie

Thanks for the update. At least now I can give them a sensible reply. Cheers Eddie

Hi Guys, I have a Dynon Skyview D1000 with Dynon GPS and Dynon Transponder. I have just received a letter from Airservices Australia asking if my ADS-B out transmissions are GNSS compliant meaning that the ADS-B information can be used for separation? Could you answer this question for me...

I would love to know the answer to this as a friend I am helping is seeing exactly the same problem. Cheers Eddie

Excellent thanks for the feedback Cheers Eddie

Hello Mr Dynon, Do you have any other hints or suggestions? I am helping out a friend with this and am scratching my head at the moment. Cheers Eddie

I am hooked up to pin 32 on the EMS harness? Cheers Eddie

Hi guys I am trying to get RPM to display from a UL-power engine. The ul power manual states the ecu puts out a 12v square wave signal for rpm. I have connected this to the skyview left rpm input, however I am seeing erratic to no rpm displayed. Has anyone solved this problem? Cheers Eddie

Hi Surfboy, I had the same problem with my #4 EGT, it ended up being a bad crimp on one of the spade connectors, try re-crimping all the connectors for your bad EGT to see if that helps before you spend money on a new probe Cheers Eddie

Thanks Guys I never would have thought to look under audio settings. Much appreciated. Cheers Eddie

Hi Guys, Is there a way to disable the audible stall warning as you accelerate to take off speed, mine goes off during every take off? I tried to work my way through the menus but nothing obvious pop out at me Cheers Eddie

OK will try cycling the power to the servos next time. At present the servos power up when the Master switch is turned on, which also powers up the Skyview. Cheers Eddie

Hi Guys, I was recently did a 3700nm trip and about half way through this trip, the roll servo came up with a roll servo failure message in the title bar of the Skyview screen. This occurred during engine start-up. While letting the engine warm up I tried to do a network discovery, but to...

Yes its the VDO style, have there been issues with these senders? Cheers Eddie