Search results

Richard The harness is a 'generic' one which was developed with the Legacy units for updating etc, I just remove them ;) Jake J

Just A thought - what is setup on the SL30 re serial output, set Indicator Head type to NONE ;) Jake J

EricR Gps track offsets are encouraged here by our Aviation Authority, many people do & I've been using it for years. Much harder to have a collision when everyone uses a small track offset between commonly used waypoints & tracks ;) Jake J

This has probably been covered before  -- Serial Communications -- in a DUAL SV setup please make sure that both screen Serial port settings are exactly the same --- don't ask how I know  ::), it's been 'fun'  :-? troubleshooting a system over the phone.  Now I know how difficult it can be for...

Cutting the Dynon harness wires (brown covering) is acceptable & I do it on every installation without any issues ;) Jake J

It's covered in another post - 'fixed' in a future software change. Jake J

Not sure what the issue is here - as it stands the EDC has 4 wires & the OAT adds another 3, they all can be accommodated within the 9pin dsub connector. Jake J

This problem can happen once in a while, I'd try increasing the resistor value in 10 or 20K increments but don't go higher than 120K - there is a device coming onto the market that eliminates this issue however more testing is needed, I'll report my results with this device later  ;) Jake J

Steve Not a problem, I connect all the grounds at one point ie Forrest of tabs (push on connectors), works well. Jake J

Bruce I think the auto plugs idea is a red herring ;) I've been running dual p-mags in a Glasair for (composite airframes can sometimes be problematic with EMI/RF ) 70 + hrs without any problems, however I also haven't installed my dual dynons yet. Jake J

Good to get the feedback, thanks  ;) We ALL make mistakes sometimes & it's easily done too  :) Having done the same thing once I now always use a permanent marker to identify each connector, especially the J1 & J2 on audio panels as they both use pins  ;) Jake J

Mitch Standard will work ;) Jake J

In a word, YES ;) Jake J

Skysailor Can you advise exactly what p/n the converters are & where to order them please ? Jake J

"...I was meticulous on wiring  :)Smiley" Steve, I believe you ;D Why I mentioned it is that I think a well known supplier of connectors has been shipping out some dsub connectors that require the insert tool to make the pins/sockets click home fully - you don't have to ask how i know  ::) as...

George FYI - I just done an upgrade from 1.08 to 5.5 without any issues, worked well ;) Jake J

Steve Just a thought (you'd probably checked this anyway) - did you confirm that the pins in 14 & 15 in the Transponder plug are actually fully seated ? :) Jake J

Bob No worries , accepted !! :) The main point here is that people are aware of differences in manufacture of the connectors & that everything needs to be checked, not just continuity of wiring :) Cheers, Jake J

Carl could you elaborate on the 'problems' please, or at least pm me - it may be useful to know to save a few other people headaches with troubleshooting 'issues'. ;) Jake j

For a few months now I've been having difficulties inserting wires into some dsub connectors ie having to use an insert tool to get them to go to the detent position but just thought that it may have been caused by a few connectors that were slightly 'out of spec'. A conversation today with an...