Search results

  1. J

    Location for SV-250-GPS

    Fred My Glasair ( note: fibreglass only & no carbon fibre) has it's Gps antenna ( IFR GX 60) mounted inside since 1998 with no issues, you can safely do the same ;) Jake J
  2. J

    Voltage for warning light

    Kenny that wire is a 'switched' ground, you need a 12volt wire from a bus for other side of light ;) Jake J
  3. J

    Is this a CHT probe failure?

    reidviator The supplied probes now have a multicore conductor so what you, I & others experienced in the past with the single conductor is no more ;) Jake J
  4. J

    EMS D-10 Grounding Questions

    Sure is! :) Jake J
  5. J

    EMS D-10 Grounding Questions

    If you connect to a ground at the D10 then that will do the job. Jake J Glasair
  6. J

    Mounting Stud Extensions

    6-32 ;) Jake J
  7. J

    New Dynon Skyview AP install

    so you're dropping the push for the AP76 then ;D ;D ;D Jake J
  8. J

    Flight Deck D180+ Garmin 150xl

    If you have the Garmin install manual it is explained in Section 4 - basically, with power off, you press & hold down the ENT key, release it when the display activates then change display to I/O CHNL 2 set page & select output to 'plotting' - that is basically it but para 4.1 of the Garmin...
  9. J

    SV Intercom VOX settings

    pc If it were me I'd check co pilots mic wiring, you say the headsets work in other planes so it's reasonable to assume the 'issue' is in your plane. An example - in a recent troubleshooting audio issue (wiring done 6 years ago) I found that pax phone audio (mono) wire had been wired to the...
  10. J

    SV Intercom VOX settings

    Some headsets have mic gain adjustment capability, maybe yours has ? Jake J
  11. J

    D60 to GTX327

    Are you saying all is working ok now ? Jake J
  12. J

    Tach setting for a Lycoming IO-540

    It's really no big deal here IMO, just try different values & it'll be obvious which one is correct - you're allowed to work this out for yourself, it won't break the box  :) Jake J
  13. J

    D60 to GTX327

    Norman You also need to configure the Gtx serial IN to Icarus Alt whether it's port 1 or 2 that you've wired the Dynon to in the GTX ;) Jake J
  14. J

    EGT Temperature Issue

    You have a PM Jake J
  15. J

    Transponder interference

    Donald You have a PM Jake J
  16. J

    Screen Blackout 10"

    Hi Bruce If heat is the issue then that's probably a function of the Jabiru panel design as it's basically a box without provision for heat, that builds up, to escape. I'd insert some mesh grilles into the top of the glareshield to let the heat flow out. I also have some of that (black...
  17. J

    Transponder interference

    Also, what is the position of the antenna relative to the headset jacks & rest of the avionics ? Did you use shielded cables for the ph/mic jacks ? Is the shield grounded at the radio or intercom end only ? Jake J
  18. J

    GPS Blinks out

    Just thought I'd add some info here- the Gps is excellent, it'll pick up satellites when Tso'd gps eg Garmin 650 won't. Just thought I'd mention that I have seen a problem with 1 only puck - it was intermittent due to an installer having flexed the wiring too much ( inadvertently of course)...
  19. J

    Transponder interference

    Donald What size is the Transponder groundplane ? Jake J
  20. J

    activating SkyView back up battery

    RTM, that's why Dynon produce it - it's all there on pages 4-7 to 4-8 vers 10.0 ::) Jake J
Top