Search results

Drew I understand your pain - I believe Dynon will do something about the text as it's in their best interest to do so.  They have had a lot of feedback from various sources including me.  As an installer the best advice, at this stage, I can give to customers who want a 7" Skyview is to buy...

An obvious question :) did you do the calibration process ? ;) Jake J

FWIW - if I was in this situation & wanted startup & idle rpm voltage stability ops then I'd fit another smaller battery say 5-7amps connected via a diode to the main electrical system so that it will give you the 12 + volts (while idling - has to be a 'good' battery) and therefore will also be...

IMO - That's not being fair - Dynon HAVE made comment, don't see a reason why they should have to keep replying to EVERY post on this subject, it's takes up valuable time that could be better spent elsewhere. Do a 'search'. Jake J ;)

Chris Plug is already on the harness - I usually remove them for installs where access to back of the SV is relatively easy, just plug the USB stick into the port there as you don't need to do this very often. ;) Jake J

DS 1. For interfacing with another display (in this case VP) what does the D10 EMS output ? 115200 ? 2. This unit has s/n 1678 (no Revision details) on outside but in setup menu s/n is 0 - what impact does this have ? Customer had done upgrade to vers 5.4 on the D10A as well but it has...

Hi John The 'red cube' is much better, don't see the issues you mentioned - I don't see me using the Flowscan units again ;) Jake J

Ds Those are the ones used with the VMS systems - I've installed a few of those in the past pre Dynon ;) Jake J

Brian I have installed an autopilot in the Tecnam - where are you based ? PM me :) Jake J

Dico From what I remember on the forum - EGT's, CHT's & fuel flow is ok to use existing, not sure about the rest. Do a search on this site. HTH Jake J

Not quite sure what to make of the tach issue. Are you using the standard 5th trigger coil pickup method? Do you have any resistors inline on the RPM pickup? Jim We need you to answer the question from DS, please  ;)   As for EGT - did you use a double jaw crimper (crimps terminal in 2...

John Try either. one will be obviously incorrect - you can't hurt the unit with the incorrect PPR. ;) Jake J

Dico Basically yes, but depending on what country you're, in as there can be some 'issues'. IMO 2 x Skyviews would be a minimum or steam gauges as backups, some like a combination of both. Jake J :)

Rob I don't think you need do anything different from adding a resistor to the P lead (I do this at the switch end) as per the Dynon manual.  I've connected Dynons to many IO-540's without an issue so my guess is there is something else in the mix here.  Do you have the shielded wires going...

Thanks for posting the result - good to know our advice helped. ;) Jake J

That would be a good move Dynon especially as, I believe, the Vision Microsystems (VMS) are NOT BEING SUPPORTED anymore. Jake J works on Defiants & Aircam ;)

FWIW - I always use the dsub 9way connectors for any 'important to flight' connections, don't forget to use one pin/socket as well for the shield wire. ;) Jake J

Chris Do you see the letters, A B C, on the connector and can confirm that the correct coloured wires are in them? ;) Jake J

Re: Any way to center bank angle/ball when on grou Contact DS direct - there are no 'field' adjustments and they'd want to look at it anyway to assess the damage. Jake J

Jeff 100k oHm should work fine - 1/4 or 1/2 watt is ok too. Jake J